Wednesday 14 April 2010

BRICK RENDER


Two coat brick effect render, used to simulate the
appearance of brickwork. A colour mortar coat is trowel applied then the top coat is applied in a contrasting colour whilst still soft. This is then carefully set out and cut back using a specialist cutting tool.

SMOOTH RENDER

This product is applied over a basecoat render at approximately 10mm thick. The surface is left to harden for a short while, then is finished with a damp sponge. This product is a cementious through-colour render allowing for a smooth finish to be achieved.

ACRYLIC FINISH


A base coat render is applied at a minimum thickness of 8mm. This is ruled to provide a flat surface. A primer coat is then applied followed by an acrylic finish at 1-2mm. The flexible anti-crack formulation and ultra-violet resistant pigments of an acrylic render allow for large areas to be seamlessly rendered with perfect colour consistency which is low maintenance and has self cleaning properties.

PEBBLE DASHING



A coloured polymer render coated with a spar dash finish. A wide range of aggragates in various colours can be used to dash the surface, which is applied at 8mm thick then dashed whilst the render is still soft.

m.singleton render sysytems

TEL: 07588 394795